Allis-Chalmers 60" x 89

ALLIS CHALMERS 60" x 89" Gyratory Crusher, Maximum feed size is 48in.
Required refurbishments have been assessed and price quotes are available upon request.
SPECS FROM KEY COMPONENTS:
BOTTOM SHELL (BASE)
-This is the straight bottom shell design.
- Lower arm wear minimal.
- Generally good condition
- No Bushings
- Liners worn out
- Mounting holes in good condition.
- Appears in serviceable condition.
- No dust collar found.
LOWER TOP SHELL
- Good condition
- Bolt holes and flanges in good condition
TOP SHELL SECTION
- Good usable condition
- Flange holes in good condition
- Tapers appear good
SPIDER
- Wear on the spider arms
- Serviceable, care should be taken to protect these surfaces when in future use.
- Some wear on the spider arms and the housing.
- Spider to top shell taper appears to be good.
- Spider rim has minimal wear.
- Spider and rim liners available.
- Spider bushing should be measured to insure it conforms to spec.
- Wear on the spider arm and spider bushing outer housing.
- Spider is suitable for further use.
SPIDER ARM LINERS- ARM GUARDS - CONCAVES
-These are used but still have plenty of service life especially if wear bars are welded on for further protection.
- Good condition
MAINSHAFT
- Appears to be in generally good condition.
- Inner head nut usable but should be replaced.
- Main shaft Sleeve is usable but should be replaced.
- Lower journal in good condition.
- Main shaft Step (Bronze) is approximately 70\% worn. It is usable as is and could be re-grooved to extend the life.
- Dust Seal retainer has normal wear. It is usable, the attachment bolts will require work to remove.
- The Dust seal should also be replaced due primarily to age.
- The splash curtain is missing.
MAINSHAFT LOWER JOURNAL
- Good condition.
HYDROSET
- Eccentric support plate is in place with eccentric wear plate (bronze)
- Appears to be in usable condition
- Some wear on flanges but usable
- The piston has been removed.
- The upper and lower Hydroset bushings are in place
- Unit has been cleaned and painted.
ECCENTRIC
- 60 X 89 Eccentric
- Appears to be in good condition
- Eccentric has been cleaned and painted
BOTTOM SHELL BUSHING
- Bottom shell bushing is used
- Cleaned and useable
ECCENTRIC SUPPORT PLATES
- There are 2
- Both appear to have had little use.
- Unit has been cleaned
PINION SHAFT-COUNTERSHAFT ASSEMBLY
- Pinion serviceable
- Housing in good condition.
- Should be disassembled and evaluated to determine condition of internals for future use.
- Cleaned and painted