Jenz HEM 360

chipping equipment set - chipper Jenz HEM 360 and tractor Valtra T171h, loading arm Farmi 4571

Tractor - 8664mh

6-cylinder diesel engine with turbo-charged, the maximum capacity of at least 184 hp
Transmission - Standard mode synchronized three-and four-speed (12 forward and reverse) gearbox with each gear three-stage electro-hydraulic power shift (as results in 36 forward gears and 36 reverse) and electro-controlled reverse box. 4-wheel drive. Speed on the road 0-50 km/h. PTO shaft 540 and 1000 rpm. Differential lock and four-wheel drive Turning electrohydraulic. Industrial front axle.
Hydraulics - hydraulic pumps yield of 73 l / min. Standard 2 of distributed ram sections with SCVs.
Cab - heating with fan, seat rotates 180 degrees. Two lockable doors. On the side of the outside of the electrical linkage extra driving interlocking unit.
PTO 1000 EHD
conditioning
Cabin bottom heater, engine heater cable
Fuel tank - 335 liters
3 SCVs couple
air seat
compressor
Air brake system
front linkage

Hydro Farmi 4571 with a maximum reachness 7, 1m and lifting power of 46, 2 kNm

Chipper - 4268 mh
Loading opening at least 400x790 mm
The rotor diameter of at least 520 mm
The number of blades 8-16
Crush log diameter up to 40cm
Speed up to 60 km/h
Tires 600/50 R 22, 5
Chipping speed is not inferior to Jenz HEM 420 - average 80m3/h
Overgrow branches - 60 to 90min / 90m3
Forest branches - 90 to 120min / 90m3
Sawmill waste, wood - 50min / 90m3

MORE INFO AND PHOTOS BY REQUEST