ROCK SYSTEMS is selling this:

Rock Systems 502-3080

Back

Make: Rock Systems
Model: 502-3080
Category: Construction / Waste, Recycling & Quarry Equipment
Location: North America: United States of America
Rock Systems, Inc. 3250 Riverside Blvd., CA 95818, Sacramento, - USA
Condition: new
Price: Price on Request

Contact Seller

Description

30" Wide x 80' Long Self-Contained Radial Stacker
30" Wide x 80' Long Portable Self-Contained Radial Stockpiling Conveyor complete as follows:
• Main frame - 30" deep truss, Chord angles - 3" x 3" x 1/4"
• Power top folding head section
• Hydraulic Raise - Pin lock height adjustment.
• Swing axle – Road portable swing axle with dual 11-22.5R tires and wheels. Designed to be used in transport and radial travel mode.
• Power Axle jacks – used to change the axle from transport to radial travel mode.
• Power travel package - 2 hp Hyd. gear motor, chain driven
• Road Portable Package – Kingpin, brakes, lights, flaps
• Drive – Self Contained Diesel Drive
• Engine – Cat Tier 4i, 65 HP Diesel with gear pump and reservoir
• Motor - Hydraulic drive with flex couplings and start stop controls
• Capacity 500 TPH, Belt Speed 300 FPM
• Drive pulley - 16" dia. crown faced, herringbone lagged drum
• Tail pulley - 14" dia. crown faced, wing type pulley
• Shafts – C1045 turned and polished, Bearings – Pillow block bearings
• Take ups - Screw type
• Belting - 2-ply 3/16 x 1/16 220 PIW, Belt splice - Flexco mechanical steel fasteners.
• Primary Belt scraper - Martin Engineering Pit Viper with tensioner.
• Loading area idlers - CEMA C, ICC, 5" dia. rolls, 20 deg. trough, sealed for life ball bearings, 16" spacing
• Troughing idlers - CEMA C, ICC, 5" dia. rolls, 35 deg. trough, sealed for life ball bearings, 4' spacing
• Return idlers - CEMA C, ICC, 5" dia. rolls, sealed for life ball bearings, 10' spacing
• Gathering trough - 6' long with adjustable rubber flashing.
• Radial receiving hopper extension - 6' bolt on design.
• Towing eye
• Anchor pivot plate - maintains tail end during radial travel.
• Guarding - Tail pulley shield, v-belt drive guard, return idler nip guards as needed, pinch points and nip guards on drive pulley. We do not warrant that our guards will meet all local codes. It is the responsibility of the end user to have them checked by a local inspector.
• Paint - (1) coat finish enamel painted Tan.